Double Cone Bipolar Tesla Coil

My Research

Ideal Tesla Magnifier System
Spiral & Solenoid Combination Coil
Flat Spiral Secondary and Longitudinal Waves
Trifilar Wye Secondary Coil
Tesla Magnifier Experiment
Magnetic Quenching Experiment
Bilfilar Electromagnet Experiment
Bucking Magnet Experiment
Fluorescent Tube Battery
Electrolytic Rectifier
Tesla Propulsion
QADI Lab
Periodic Tables

Tesla Resources

Known Tesla Publications
Articles About Tesla and His Work
Tesla Notes
Tesla Photos

Privacy Policy

Content on this page requires a newer version of Adobe Flash Player.

Get Adobe Flash player

Vajra Periodic Table print
Vajra Periodic Table
by Aether Wizard

Formulas

My Inductance Formula
Relationships of Frequency
Experimenter's Handbook
Wheeler - formulas for inductance
Measure Inductance w/o LCR Meter

Of Interest

Tesla Coil Mailing List
High Voltage

Ideal Tesla Magnifier System

Pulse Graphic

Pulse Graphic

In the above pulse graphic, two radiating circles expanding outward and toward each other and then contract while moving away from each other. The movement scans an area representing the pulse.  Visualize the area between opposing pairs of circles as the surface of an imaginary cylinder (not shown, but inferred.)  The area of the cylinder is equal to the total power of the field in a Tesla coil.

We visualize this mathematically by looking at the electric and magnetic fields of the electromagnetic pulse for the case of a flat spiral coil. 

Electric field strength is -
ε = E / d Volts per meter

E is the potential in Volts and d is the distance between two potentials.  Similarly, magnetic field strength is -

H = F m / l   Ampere turns per meter
where l is the length of the field line and magnetomotive force Fm is -

F m = I × N   Ampere-turns 

The formula for calculating the length of wire in a flat spiral coil is -

l = 2π x R avg x N

Where l is the length of wire, R avg is the average radius of the coil, and N is the number of turns.  Thus

N / l = 1 / (2π x R avg)

and

H = I / 2π x R avg

To get the total field power -

P f = ε x H or

P f = V x I / 2π x R avg x d   Watts per cylinder

Where 2π x R avg x d is a cylinder as inferred in the diagram above. 

From this, the nature of longitudinal waves in a flat spiral coil can be understood.  The longitudinal wave is represented by current and circumference of the radius.  It is clear the longitudinal component of the flat spiral coil remains in the coil at all times.  In actuality, the full length of the flat spiral secondary fills up with charge much like a hose fills up with water.  The "crest" of the water wave in the hose corresponds with the longitudinal "head" of the wave.  Each time the head of the wave makes one full circle, it would appear from a radius perspective that a beat had occurred in the expansion of the wave from its center toward the outer winding.

The sum of all circumferences of the radii of the coil (same as total wire length of coil)  is what I call the "stroke". 

curr = coulomb 2 / sec

stroke = meter / coulomb2

velc = meter / sec

velc = curr x stroke

Where velc is the velocity of the total electron magnetic charge.

As the current flows through the flat spiral coil, the energy of each successive winding adds in the direction of the propagation of the pulse.  This is seen in the pulse model as the x axis and the units are in meters per second which is equal to the current times stroke.  The potential in a flat spiral coil is not linear.  Just as the magnetic field is equal to current divided by 2π times average radius, the electric field is equal to potential divided by vertical distance between two opposite charges.  In a flat spiral coil oriented parallel to the surface of the earth, a negative charge builds under the coil and a positive charge builds above the coil. 

It is the free distance above and below the coil that increases the energy potential and allows the energy to penetrate the permeability of the surrounding space. 

But since the flat spiral coil is a closed system of copper atoms, the charge reaches the end of the wire, and since the charge is practically incompressible, the charge momentum immediately reverses direction and heads for the center of the flat spiral coil.  At the maximum outer windings of the flat spiral coil the cylinder defined by total power of the electromagnetic field is spread out, but as the coil radius becomes minimum the cylinder representing the total power would like to expand along the z axis.  In a flat spiral coil, the z axis is only one winding high. This causes the power at the center to have high current and relatively low potential compared to a solenoid coil.

Due to the nature of the expanding cylinder of total field power, it can be seen that a flat spiral coil wound completely to the center of the coil will have the greatest effect on the voltage as the stroke will be the shortest and hence the current will be in its most dense state.  From the point of view of the total power output in the coil, the power will be mostly transferred to potential if the flat spiral coil is wound to the center.  But a flat spiral coil wound completely to the center, of itself, can only produce a high rate of current because there is no distance along the z axis for the voltage to travel in.  So to effect the most efficient and most complete transfer of power between current and voltage a coil must be wound with both a flat spiral secondary and tall solenoid secondary connected to each other.  This configuration happens to be the ideal "magnifier" setup used by Nikola Tesla in his World Transmitter System.

By placing a coil of small radius and tall height in the center of the flat spiral coil, the optimum condition for transferring the energy of declining radius is presented to the charge.  Now as the charge declines in radius and tends to increase in distance from the coil, the distance of the charge will expand along the tall solenoid and each successive turn will add to the potential thus allowing the charge to penetrate the surrounding permeability with great force.

The momentum of the expanding potential is such that it has the force to electrostatically induce movement into surrounding charged particles.  This can cause radio waves. 

Per the Aether Physics Model, the rotational component of the flat spiral coil's current occurs as the head of the charge moves from the center winding to the outer winding and back. There is also a rotational component radiating from the wire's circumference. The rotational component is further maintained by the solenoid between the top winding and lower winding.  In effect, the cylinder defined by the total field power rotates as a single unit in one direction when the potential is declining and in the opposite direction when the potential is increasing.  It would follow that in certain cases a spiral effect would be noticeable in the discharge of the upper solenoid terminal.  Such rotational effects have been noticed by several coilers.

In Tesla's Wardencliffe magnifier, the frequency of the flat spiral coil was tuned to the resonant frequency of the earth.  The solenoid was wound to oscillate at many times the frequency of the earth such that it would generate high potential.  The high potential of the solenoid helped drive the current in the flat spiral coil just as the current in the flat spiral coil helped drive the solenoid.  The high potential creates a strong electrostatic charge at the top of the coil and away from the ground. When the coil system is slightly detuned, the electrostatic charge begins to oscillate up and down the coil and acts like an electrostotatic pump. When the frequency of the rising and falling electrostatic field is equal to the Earth's resonant frequency (Schumann resonance), the Earth's electrostatic field comes into resonance. It was this resonance of the electrostatic field that made wireless power transmission possible.

Today, this wireless power transmission scheme is being applied to computers, cell phones, and other devices with low power requirements.